Power Supply Information
A power supply plugged into a non-GFCI or non-RCD receptacle could result in electric shock.
Plug the power supply into only a ground-fault circuit interrupter (GFCI) or residual-current device (RCD) receptacle with a tripping current not more than 30 mA.
A malfunctioning or damaged charging station, low-voltage cable, or power supply could overheat and cause an increased risk of fire.
Do not install the charging station, low-voltage cable, or power supply near flammable or combustible materials.
If the power supply to the charging station is malfunctioning or damaged, disconnect the power supply, and contact an Authorized Service Dealer to replace it.
Check to ensure compliance with all codes and regulation before mounting the power supply.
Mounting the power supply may require additional materials and/or hardware, depending on the type of base material present at your chosen mounting location.
Route the power cord to the charging station outside of the mowing area; otherwise, the mower may damage the cord.